Changing Needles - Sears Kenmore 385.19030 Manual De Instrucciones

Changing Needles
[] Raisethe needleby pressing the up/downneedle
button and lower the presserfoot,
Turnoff the power switch,.
Loosenthe needleclamp screw by turning it
counterclockwise_
Removethe needlefromthe ctamp_
[] Insertthe new needleinto the needleclamp with
the flat sideto the rearm
Wheninsertingthe needleinto the clamp, pushit
up as far as it will go_ Tightenthe clamp screw
firmly by turning it clockwise,
[_ Tocheck for a good needle,put the flat side of
the needleonto somethingflat (theneedleplate,
glass,etc_).
The gap betweenthe needleandthe flat surface
should be consistent° Neverusea bent or blunt
needle.
(_ Needle clamp screw
Pin
(_) Needle clamp
To Attach and Remove Presser Foot
[] Press the red button on the back of the foot
holder° The presser foot will drop off.
[] Place the selected presser foot so the pin on the
foot lies just under the groove of the foot holder.
Lower the presser bar to lock the foot in place.
Q Red button
(_) Groove
(_ Pin
To Remove and Attach the Foot Holder
To Remove:
Remove the thumb screw by turning the screw
counter-clockwise with the screwdriver.
[] To Attach:
Match the hole in the foot holder with the threaded
hole in the presser bar°
Fit the thumb screw into the hole.
Tighten the screw by turning it clockwise.
(_ Thumb screw
(_ Foot holder
Presser bar
[] []
%
[]
f
[]
[]
[]
......... J
J
26