Idiomas disponibles
Idiomas disponibles
22.4.3. Commissioning
1. Make sure the control device is in binding mode.
2. Press and hold the two upper or two lower buttons. The device tries to bind to the control
device. It shows the result on the status LED.
22.5. OPERATION
(See section 4 for more visual instructions)
1. Press the required button.
For button C:
• press 1x for 30 minutes
• press 2x for 60 minutes
• press 3x for 90 minutes
The device shows the result on the status LED.
22.6. FILTER DIRTY RESET
To reset the fi lter dirty message, press and hold AWAY and PARTY for at least 4 seconds.
22.7. REPLACING THE BATTERY
(See section 4 for more visual instructions)
1. Remove the buttons from the unit.
2. Loosen the clips and separate the unit from the mounting plate.
3. Replacing the battery:
a) Remove the old battery.
b) Place the new battery. The LED shortly shows orange.
4. Place the device onto the mounting plate.
5. Place the buttons.
22.8. TECHNICAL DATA
22.8.1. Dimensions
Overall dimensions (h x w x d): 84 x 84 x 15 mm
Weight:
22.8.2. Ambient conditions
Operating Temperature Range:
Shipping & Storage Temperature Range: -20 to 55° C
Relative Humidity:
Ingress protection (IEC60529):
22.8.3. Battery specifi cation
Type:
Battery lifetime:
22.8.4. Wireless connection specifi cations
Communication frequency:
Output power:
You are not allowed to use the device outside of Europe.
± 125 g
0 to 40° C
0-90%, non-condensing
IP30
CR2032
6 years
868.3 MHz
at least 0 dBm.
a
b
47
