Warnings - THERMEx SWINDON Instrucciones De Uso

B 54521706209112016

WARNINGS

• The range hood is designed and
manufactured according to DS/EN
60335-1.
• This range hood is only for use in private
house holdings, if used for other
purposes the warranty will be repealed.
• Installation must be performed by a
skilled electrician in accordance with the
specifications given by Thermex
Scandinavia A/S (Thermex) and
legislation in force.
• Thermex disclaims all responsibility in
regards to damages caused by wrong
installation, mounting or use.
BEFORE MOUNTING/COMMISSIONING
• Inspect the range hood for transport
damages, flaws and defects immedia-
tely after the receipt.
• Transport damages must be filed to the
haulage contractor and Thermex
immediately after the receipt.
• Flaws and defects must be filed to
Thermex within 8 days the receipt, and
not later than mounting/commissioning.
MOUNTING
• The range hood is intended for working
at 230 Volt ±10%~ 50 HZ ±10% in
referring to EN 50160.
• The range hood must have earth.
• For models with external motor applies
that NOT to use common zero by
installing the hood and engine, as this
will affect the control.
THERMEX SWINDON 45
• It MUST be ensured that the motor can
be used with the selected range hood
when using an external motor from
another supplier. Otherwise the
warranty no longer apply.
• Do not plug in the range hood until the
mounting is complete.
• The air must not be discharged from the
hood into a pipe used for extraction
from devices using gas or other fuels.
Such devices must have a separate vent.
• The national legislation on air emissions
must be observed.
• Always use the original dimension of the
vent. By reducing the dimension of the
vent, the performance will be reduced
and the sound level will be increased.
• The vent to the open air, must be as
short as possible in order to get the
greatest possible capacity of the range
hood.
• The number of bends on the vent ought
to be minimised, to gain the greatest
possible capacity of the range hood.
• Thermex recommends to always use
sound and condensation insulated vent
hose at the carrying through in
unheated spaces.
• Thermex recommends that there is used
for a muffler to minimize the noise level
when using flexible hose.
• Using the flexible hose must always
ensure that this is fully extended to
minimize air resistance and thereby
achieve maximum absorbency.