Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Read and understand all safety precautions in this manual before operating. Failure to
comply with instructions in this manual could result in personal injury, property damage,
and/or voiding of your warranty. The manufacturer WILL NOT be liable for any damage
because of failure to follow these instructions.
area. It is normal for the motor and
pressure switch to produce sparks while
operating. If sparks come into contact with
vapors from gasoline or other solvents,
they may ignite, causing fire or explosion.
Always operate the compressor in a well–
ventilated area. Do not smoke while
spraying. Do not spray where sparks or
flame are present. Keep compressor as far
from spray area as possible.
2. RISK OF BURSTING. Do not
weld, drill or modify the air tank
of this compressor. Welding or
modifications on the air
compressor tank can severely impair tank
strength and cause an extremely hazardous
condition. Welding or modifying the tank in
any manner will void the warranty.
3. RISK OF ELECTRICAL
SHOCK. Never use an electric
air compressor outdoors when
it is raining or on a wet surface,
as it may cause an electric shock.
4. RISK OF INJURY. This unit
starts automatically. ALWAYS
shut off the main power
disconnect, and bleed all
pressure from the system before servicing
the compressor, and when the compressor
is not in use. Do not use the unit with the
shrouds or belt guard removed. Serious
injury could occur from contact with
moving parts.
5. RISK OF BURSTING. Check
the manufacturer's maximum
pressure rating for air tools and
accessories. Compressor outlet
pressure must be regulated so as to never
exceed the maximum pressure rating of the
tool. Relieve all pressure through the hose
before attaching or removing accessories.
WARNING
1. RISK OF FIRE OR
EXPLOSION. Never
spray flammable
liquids in a confined
6. RISK OF BURNS. High
temperatures are generated by
the pump and manifold. To
prevent burns or other injuries,
DO NOT touch the pump, manifold or
transfer tube while the pump is running.
Allow them to cool before handling or
servicing. Keep children away from the
compressor at all times.
7. RISK TO BREATHING. Be
certain to read all labels when
you are spraying paints or toxic
materials, and follow the safety
instructions. Use a respirator mask if there
is a chance of inhaling anything you are
spraying. Read all instructions and be sure
that your respirator mask will protect you.
Never directly inhale the compressed air
produced by a compressor. It is not
suitable for breathing purposes.
8. RISK OF EYE INJURY.
Always wear ANSI Z87.1
approved safety goggles when
using an air compressor. Never point any
nozzle or sprayer toward a person or any
part of the body. Equipment can cause
serious injury if the spray penetrates the
skin.
9. RISK OF BURSTING. Do not
adjust the relief valve for any
reason. Doing so voids all
warranties. The relief valve has
been pre-set at the factory for the
maximum pressure of this unit. Personal
injury and /or property damage may result if
the relief valve is tampered with.
10. RISK OF BURSTING.Do not
use plastic or pvc pipe for
compressed air. Use only
gavanized steel pipe and fittings
for compressed air distribution lines.
11. RISK OF BURSTING.Failure
to properly drain condensed
water from air tank, causing rust
and thinning of the steel air
tank. Drain air tank daily or after each use. If
air tank develops a leak, replace it
4- ENG
Tabla de contenido
