Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Cleaning and Maintenance
6mm
BURNERS
Remove the burner lids and Flame Spreaders by pulling them upwards and away
from the top plate.
Soak them in hot water and a little detergent or washing up liqui.
After cleaning and washing them, wipe and dry them carefully. Make sure that the
flame holes are clean and completely dry.
Wipe the fixed parts of the burner cup with a damp cloth and dry afterwards.
Gently wipe the ignition device and flame supervision device with a well wrung-out
cloth and wipe dry with a clean cloth.
Before placing the burners back on the top plate, make sure that the injector is not
blocked.
Re-assemble the Auxiliary, Semi-Rapid, Rapid and
Triple-Crown burners as follows:
1.
Place the flame spreader ( 4 ) on to the burner cup ( 5 ) so that the ignition device
and the flame supervision device extend through their respective holes in the flame
spreader. The flame spreader must click into place correctly.
2.
Position the burner lid ( 1,2,3 ) onto the flame spreader ( 4 ) so that the retaining
pins fit into their respective recesses.
Replace parts in the correct order after cleaning.
- Do not mix up the top and bottom.
- The locating pins must fit exactly into the notches.
3mm
2 1
3
4
5
6
7
2
3
4
7
6
5
13
2
3 1
4
6
7
5
Tabla de contenido
Solución de problemas
