Idiomas disponibles
Idiomas disponibles
Installation
A
STEP 7 Final check and power on
• Before using your washer, make sure to remove the dehumidifying agent (silica gel)
from inside the upper washer.
• Do not eat or swallow the dehumidifying agent (silica gel).
• The protective cover may form moisture on its surface after the washer has checked
for a leak to ensure normal operation. This is normal, and does not indicate a defective
part. Open the cover for a moment to remove the moisture.
• Plug the power cord into an AC 120 V / 60 Hz / 15 AMP approved electrical outlet
protected by a fuse or circuit breaker. Then, press POWER to turn on the washer.
34
English
DC68-03768A-10_IB_WV9900M_EN.indd 34
NOTE
To position using the pipe connector
You washer comes with a pipe connector
that is designed to join the upper drain
hose and the lower drain hose. You can
choose to use the connector to combine
two drain hoses into a single outlet.
1. Insert the clamp ring on the end of the
drain hose, one for each drain hose.
2. Insert the pipe connector into the drain
hoses. Make sure the longer side (A) fits
into the drain hose running from the
lower washer.
3. Fix the position of the clamp rings near
the end of each hose.
• To remove the pipe connector, follow
these steps above in the reverse order.
2023-06-27
7:18:40
