Idiomas disponibles
Idiomas disponibles
Installation
STEP 3 Adjust the levelling legs
STEP 4 Put the rubber cups on the legs (Only for soft floor or surface)
26
English
DC68-03768A-10_IB_WV9900M_EN.indd 26
1. Gently slide the washer into position.
Excessive force may damage the
levelling legs.
2. Level the washer by manually adjusting
the levelling legs.
3. When levelling is complete, tighten the
nuts using the wrench.
NOTE
An adjustable wrench or 17 mm open-
end wrench is required to loosen or
tighten the leveling legs.
To protect a soft floor or surface, use the
provided rubber cups. You don't need to
use the rubber cups on a hard floor or on a
pedestal.
1. Let two or more persons hold both
sides of the washer.
2. While slanting the washer to one side,
put the rubber cups under each leg of
the washer one by one.
CAUTION
Make sure you have two or more persons
insert the rubber cups. Otherwise, the
washer may fall, causing physical or
property damage.
2023-06-27
7:18:36
