Idiomas disponibles
Idiomas disponibles
mechanical stress.
Never combine different types of
„
rechargeable batteries or batteries with
different charge statuses.
z Risk of leakage from
rechargeable batteries
Avoid exposing rechargeable batteries to
„
extreme conditions and temperatures, e.g.
radiators or direct sunlight.
Avoid contact with skin, eyes and mucous
„
membranes! In the event of skin contact
with battery acid, rinse the affected area
immediately with plenty of clean water and
seek medical advice immediately!
WEAR PROTECTIVE GLOVES!
„
Leaking or damaged rechargeable
batteries can cause chemical burns
if they come into contact with skin.
Therefore, wear suitable protective gloves in
such cases.
In the event of battery leaks, remove the
„
battery from the product immediately to
avoid damage.
z Assembly and installation
Please note: Take the product out of its
packaging and remove all packing material.
Check that all package contents are
„
present.
Check if the product or individual parts are
„
damaged. If that is the case, do not use the
product. Please contact the distributor via
the service address indicated.
Screw the stand
„ „
5
floodlight
(see fig. B).
1
Align the holes with each other as shown in
„ „
fig. B and fix this position with the hinge
screws
on the left and right.
7
Before using the product for the first time,
„ „
please fully charge the battery (see section
'Charging the battery').
onto the foldable
z Positioning the product
You can adjust the position of the product
vertically and horizontally.
Using the handle
„ „
2
a flat, even surface. Make sure that the
stand is stable. Protect easily damaged
surfaces before setting up the product.
First, unfold the LED panels
„ „
and right (see fig. C). The LED module
is now visible.
The LED panels
„ „
3
vertically to any angle.
Loosen the hinge screws
„ „
LED module
horizontally (see fig. E).
4
Once the desired position has been
„ „
achieved, refasten the hinge screws.
z Operation
Please note: Only operate the product if it
is on a suitable surface.
The product can be operated in different
modes. These can be selected by pressing
the ON/OFF button
Start by positioning the product (see
„ „
chapter titled "Positioning the product").
Press the ON/OFF button
„ „
switch between modes:
Press 1 x - 100%
Press 2 x - 50%
Press 3 x - Off
z Charging the battery
Press the button to check the charge level of
„ „
the battery
(see Fig. D).
9
The charge indicator
„ „
indicates the charge status of the
rechargeable batteries: 25% - 50% - 75%
- 100%. The first LED will start flashing
when the battery charge is low.
Please note: The product cannot be
switched on during the charge process.
, place the product on
to the left
3
4
can be aligned
to align the
7
(see Fig. D).
11
as follows to
11
(see Fig. D)
8
GB/IE/NI/CY/MT
45
