Idiomas disponibles
Idiomas disponibles
Upholstery
attachment
ATTACHING/REMOVING (FIG.
A)
1.
Make sure that the iron/
steamer and attachment
are cool.
2. Hook the top of the
attachment over the top
edge of the steamer.
3. Click the bottom edge into place.
4. Remove attachments by lifting them away from your
iron/steamer starting at the heel. When removing the
attachment, watch out for condensation that may
have built up during use.
FILLING
1.
Place the
iron/steamer
as shown
(Fig. B). You
B
can also
6
Refresh and clean larger materials
such as bedding, mattresses,
curtains, soft toys, sofas and much
more.
Always test for colorfastness and
heat sensitivity on an inconspicuous
area.
A
place your iron/steamer on the heat resistant storage
bag.
2. Open the water inlet cover (Fig. C).
3. Pour slowly, to let the air in the
reservoir escape, otherwise you'll
cause an air lock and the water will
overflow.
4. Don't fill past the max marking or
water will escape in use.
5. To refill at any time during use, turn the iron/steamer
off by pressing the power button until the blue
indicator light goes out, unplug from outlet, and
follow the above procedure.
6. After refilling, allow to reheat for 45 seconds and then
prime the pump by holding the steam trigger until
steam forms.
USING
1.
If the label says "do not iron" or shows this icon
install the delicate attachment and make sure to test
on an inconspicuous area prior to steaming the entire
garment.
2. If the label says "do not steam" or shows this icon
do not steam the garment.
3. Hang the garment in an area that will not be
affected or damaged by the heat and steam, such
as on a shower curtain rail, or in an open doorway.
Alternatively, place the garment on a bed or towel.
C
,
,
