Ohyama WOOZOO IHF-1201G-E Manual De Usuario página 21

Operation guide
1.
After putting through the power, press "ON/OFF" button on remote controller to
turn on the air conditioner.
t
2.
Press "MODE" button to select your required mode: AUTO, COOL, DRY, FAN,
HEAT.
3.
Press "▲" or " " button to set your required temperature.
4.
Press "FAN" button to set your required fan speed: auto, low speed,
g
low-medium speed, medium speed, medium-high speed, high speed.
5.
Press "
Replacement of batteries in remote controller
rt
g
1. Press the back side of remote controller marked
with "
the cover of battery box along the arrow
direction.
2. Replace two 7# (AAA 1.5V) dry batteries, and
e
make sure the position of "+" polar and "-" polar
are correct.
"
3. Reinstall the cover of battery box.
NOTICE
e,
● During operation, point the remote control signal sender at the receiving
window on indoor unit.
● The distance between signal sender and receiving window should be no
more than 8m, and there should be no obstacles between them.
n
● Signal may be interfered easily in the room where there is fluorescent lamp
or wireless telephone; remote controller should be close to indoor unit
during operation.
● Replace new batteries of the same model when replacement is required.
● When you don't use remote controller for a long time, please take out the
batteries.
● If the display on remote controller is fuzzy or there's no display, please
replace batteries.
" button to select fan blowing angle.
", as shown in the fig, and then push out
Signal sender
18
Battery
Reinstall
Remove
Cover of battery box