Introduction for buttons on remote controller
If start this function, the unit will run at super-high fan speed to cool or heat quickly
so that the ambient temp. approachs the preset temp. as soon as possible.
5
g
● Press "▲" or " " button once increase or decrease set temperature 1°C (°F).
Holding "▲" or " " button, 2s later, set temperature on remote controller will
change quickly. On releasing button after setting is finished, temperature indica-
tor on indoor unit will change accordingly.
● When setting TIMER ON, TIMER OFF or CLOCK, press "▲" or " " button to
adjust time. (Refer to CLOCK, TIMER ON, TIMER OFF buttons)
6
Press this button can select left & right swing angle. Fan blow angle can be selected
circularly as below:
Note:
● Press this button continuously more than 2s, the main unit will swing back an forth
from left to right, and then loosen the button, the unit will stop swinging and
present position of guide louver will be kept immediately.
● Under swing left and right mode, when the status is switched from off to
press this button again 2s later,
this button again within 2s, the change of swing status will also depend on the
circulation sequence stated above.
● The
7
Press this button can select up & down swing angle. Fan blow angle can be selected
circularly as below:
● When selecting "
louver will automatically swing up & down at maximum angle.
● When selecting "
Horizontal louver will stop at the fixed position.
● When selecting "
Horizontal louver will send air at the fixed angle.
● Hold "
to
your required angle, release the button.
button
button
No display
(stops at current position)
function is only available for some model.
button
No display
(horizontal louvers stops
at current position)
", air conditioner is blowing fan automatically. Horizontal
,
,
,
,
,
", air conditioner is blowing fan at fixed angle.
" button above 2s to set your required swing angle. When reaching
status will switch to off status directly; if press
, ", air conditioner is blowing fan at fixed position.
12
, if