Ohyama WOOZOO IHF-1201G-E Manual De Usuario página 19

Introduction for buttons on remote controller
14
LIGHT button
" Press this button to turn off display light on indoor unit. "
ler disappears. Press this button again to turn on display light. "
15
Press this button to achieve the on and off of health and scavenging functions in operation
status. Press this button for the first time to start scavenging function; LCD displays "
Press the button for the second time to start health and scavenging functions
simultaneously; LCD displays "
health and scavenging functions simultaneously. Press the button for the fourth time to start
health function; LCD display "
● This function is applicable to partial of models.
16
By pressing this button, you can see indoor set temperature, indoor ambient
temperature or outdoor ambient temperature on indoor unit's display. The
setting on remote controller is selected circularly as below:
● When selecting "
on indoor unit displays set temperature.
● When selecting "
g
displays indoor ambient temperature.
● When selecting "
displays outdoor ambient temperature.
Note:
● Outdoor temperature display is not available for some models. At that time,
indoor unit receives "
● It's defaulted to display set temperature when turning on the unit. There is no
display in the remote controller.
● Only for the models whose indoor unit has dual-8 display.
● When selecting displaying of indoor or outdoor ambient temperature, indoor
temperature indicator displays corresponding temperature and automatically turn
to display set temperature after three or five seconds.
Function introduction for combination buttons
Energy-saving function
n
Under cooling mode, press "TEMP" and "CLOCK" buttons simultaneously to start up or
turn off energy-saving function. When energy-saving function is started up, "SE" will be
shown on remote controller, and air conditioner will adjust the set temperature
automatically according to ex-factory setting to reach to the best energy-saving effect.
Press "TEMP" and "CLOCK" buttons simultaneously again to exit energy-saving function.
button
TEMP button
" or no display with remote controller, temperature indicator
" with remote controller, temperature indicator on indoor unit
" with remote controller, temperature indicator on indoor unit
" signal, while it displays indoor set temperature.
" and " ". Press this button for the third time to quit
". Press this button again to repeat the operation above.
No display
16
" icon on remote control-
" icon is displayed.
".