Oerlikon CITOSTEEL 255C Manual De Instrucciones página 29

P.81 Electrode Polarity
P.99 Show Test Modes
P.323 System Update
Service Menu
It allows the access to special service
functions.
WARNING
Service Menu is available when USB storage device is
connected.
Figure 63.
Table 16.
Symbol Description
Service weld logs
Weld History
SnapShot
Service weld logs – allows recording welding
parameters which were using during the welding.
To access the menu:

Make sure that USB device is connected to welding
machine

Access to the Settings and Configuration Menu.

Use the Right Knob [36] to highlight the Service Menu
icon

Press the Right Knob [36] – the recording process will
started.
English
Used in place of DIP switches for configuration of the work and electrode sense
leads

"Positive" (default) = Most GMAW welding procedures use Electrode
Positive welding.

"Negative" = Most GTAW and some inner shield procedures use Electrode
Negative welding.
Uses for calibration and tests.

"No" (factory default) = Turned off;

"Yes" = Allows to selection test modes.
Note: After the device has been restarted the P.99 is "NO".
This parameter is active only when the USB Memory Stick (with upgrade file) is
connected to USB socket.

Cancel – goes back to Configuration Parameters menu

Accept – starts updating process



Note: To stop the recording go to Service
Menu and press the Service weld logs icon again
26
Figure 64.
Press the Right Knob [36] to continue.
Figure 65.
Press the Left Knob [35] or Button [37] to exit
Recording icon will appear on the Status
bar [38].
English