Oerlikon CITOSTEEL 255C Manual De Instrucciones página 26


Press the Right Knob [36]. The Job Mode Menu is
shown on the display.

Use the Right Knob [36] to highlight one of the option
shown on the figure below.
X
- Cancel Job Mode

- Activate Job Mode
Figure 55.

Press Right Knob [36] to confirm the selection.
Note: After activated Job Mode the icon of this function
will be displayed on the Welding Parameters Bar.
Also the Load Memory and Save Memory options will be
blocked in this mode.
Set the Language
interface language (English, Polish, Finnish,
French, German, Spanish, Italian, Dutch,
Romanian).
To set the language:

Access to the Settings and Configuration Menu.

Use the Right Knob [36] to highlight the Set the
Language icon.
Figure 56.

Press the Right Knob [36]. The Language Menu is
shown on the display.
Figure 57.
English
– user can choose

Use the Right Knob [36] to choose the Language.

Confirm the select – press the Right Knob [36].
Restore Factory Settings
Note: After Factory Settings restore, the
settings stored in user memory are deleted.
To restore Factory Settings:

Access to the Settings and Configuration Menu.

Use the Right Knob [36] to highlight the Restore
Factory Settings icon.

Press the Right Knob [36]. The Restore Factory
Settings Menu is shown on the display.

Use the Right Knob [36] to highlight the Check Mark.

Confirm the select – press the Right Button [36]. The
factory settings are restored.
Diagnostic Information
Available information:

Software Version

Hardware Version

Welding Software

Ethernet IP Address

Power Source Protocol

Event Logs

Fatal Logs.
23
Figure 58.
Figure 59.
English