Makita DRT50 Manual De Instrucciones página 10

NOTE: You can use the trimmer base (resin) as an
optional accessory as shown in the figure. When
using the trimmer base (resin), loosen or tighten the
thumb nut instead of opening or closing the lock lever.
► 1. Thumb nut
2. Close the lock lever.
3. Attach the dust nozzle to the trimmer base, and
then tighten the thumb screw.
► 1. Dust nozzle 2. Thumb screw
1
1 2
To remove the base, follow the installation procedure
in reverse.
CAUTION:
When using the tool with the trim-
mer base, be sure to install the dust nozzle on the
trimmer base.
NOTE: In some countries, the dust nozzle may not be
included in the tool package as standard accessory.
Installing or removing the tilt base
Optional accessory
1. Open the lock lever of the tilt base, then insert the
tool into the tilt base aligning the groove on the tool with
the protrusion on the tilt base.
► 1. Lock lever
2. Close the lock lever.
To remove the base, follow the installation procedure
in reverse.
Installing or removing the offset
base
Optional accessory
1. Press the shaft lock, then loosen the collet nut.
1
2
► 1. Collet nut 2. Shaft lock 3. Wrench
10 ENGLISH
1
3