Jonsered CS 2250S II Manual De Usuario página 3

5. Rear handle
6. Information and warning decal
7. Start/stop switch
8. Fuel tank
9. Starter housing
10. Starter rope handle
11. Chain oil tank
12. Product and serial number plate
13. Throttle trigger lockout
14. Throttle trigger
15. Front handle
16. Muffler
17. Saw chain
18. Bar tip sprocket
19. Guide bar
20. Spiked bumper
21. Chain catcher
22. Chain tensioning screw
23. Clutch cover (CS 2245 II)
24. Right hand guard
25. Clutch cover (CS 2245S II, CS 2250S II)
26. Chain tensioning wheel (CS 2245S II, CS 2250S II)
27. Knob (CS 2245S II, CS 2250S II)
28. Transportation guard
29. Combination wrench
30. Operator's manual
31. Vibration damping system, 3 units
Symbols on the product
Stop.
Be careful and use the product correctly.
This product can cause serious injury or
death to the operator or others.
Read the operator's manual carefully and
make sure that you understand the
instructions before you use this product.
Always wear approved protective helmet,
approved hearing protection and eye
protection.
Use 2 hands to operate the product.
1049 - 005 - 21.06.2021
Do not operate the product with one hand
only.
Do not let the guide bar tip touch an
object.
Warning! Kickback can occur when the
guide bar tip touches an object. A
kickback causes a lightning fast reverse
reaction that throws the guide bar up and
in the direction of the operator. Can cause
serious injury.
Chain brake, engaged (right). Chain
brake, disengaged (left).
Choke.
Idle adjustment screw.
High speed needle.
Low speed needle.
Air purge bulb.
Chain oil.
Fuel.
Adjustment of the oil pump.
XX
Computed kickback bar stopping angle
without actuated chainbrake, CKA wob.
3