Tabla De Contenido; Thanks For Choosing Toto; Before Installation; Warnings - Toto TSPTM Manual De Instrucciones

Thanks for Choosing TOTO! .............................................................................. 2
Before Installation ................................................................................................ 2
Warnings ............................................................................................................... 2
Installation Procedure ....................................................................................... 3-4
Maximum Temperature Adjustment .................................................................. 5
Cartridge Replacement ....................................................................................... 6
Warranty................................................................................................................ 7
Rough-In Dimensions .................................................................................. 20-21
The mission of TOTO is to provide the world with healthy, hygienic and more
comfortable lifestyles. We design every product with the balance of form and
function as a guiding principle. Congratulations on your choice.
Observe all local plumbing codes.
„
Flush all water lines prior to installation.
„
Make sure the water supply is shut off.
„
Read these instructions carefully to ensure proper installation.
„
TOTO reserves the right to update product design without notice.
„
For safe operation, please observe the following:
„ Use only 1/2" or greater copper tube and one 90° elbow for con-
nection from valve to tub spout.
„ Tub spout shall be installed 12"± 1" below valve center.
„ The showerhead must be installed 40" or more above valve center.
„ Do not install a shut-off device after the valve.
„ RISK OF SCALDING: This valve must have the maximum tempera-
ture adjusted after installation (see page 5).
„ Recommended operating pressure:
ƒ Minimum pressure.........20 psi (0.14 MPa)
ƒ Maximum pressure........80 psi (0.14 MPa)
„ If you are soldering during installastion, do not apply excessive heat to
the valve body. Excessive heat may damage internal components.
„ Hot water supply temperature should not exceed 120°F (49°C).
„ Do not use this valve at an ambient temperature below 32°F (0°C).
„ Insulate the hot water supply pipe to minimize heat loss.
„ Do not use steam for the hot water supply.
„ Do not disassemble the valve cartridge.
TABLE OF CONTENTS

THANKS FOR CHOOSING TOTO!

BEFORE INSTALLATION

WARNINGS

2