Idiomas disponibles
Idiomas disponibles
STEP 3B: INSTALLING ON A WOODEN WALL
1. Drill the previously marked holes with a drill and 6mm bit. The holes must be at least 8cm deep.
2. Insert the wood screws
The side of the bracket with a notch must be pointing upwards.
3. Gently push in the screws and turn them manually at first, then tighten using the appropriate Allen
key or an adjustable spanner.
1
≥8cm
Drilled holes Ø6mm
STEP 4: INSTALLING THE AWNING
A
Once the brackets are installed correctly, you can start to install the awning.
2 people are needed for this step. Use a ladder to carry out the installation and make sure that it is stable.
1. Insert the torsion bar into the notch in the bracket.
2. Place and screw in the
30/09/2019
≥9cm
20
into the holes of the awning brackets 13 , then into the pre-drilled beam.
2
Wood screw Ø8mm
15
nut and bolt on each bracket.
1
13
3
20
13
2
2
EN
15
27
