Idiomas disponibles
Idiomas disponibles
If the engine doesn't start:
If you did not move the Master Control
lever from cold start l to warm start n
quickly enough after the engine began to
fire, the combustion chamber is flooded.
:
Use the combination wrench to
open the fasteners (1) in the
direction of the arrows.
:
Remove carburetor box cover (2).
:
Pull off the spark plug boot (3).
MS 441 C
:
Unscrew and dry off the spark plug.
:
Set the Master Control lever to $
:
Crank the engine several times with
the starter to clear the combustion
chamber.
:
Install the spark plug and connect
the spark plug boot (press it down
firmly) – fit the carburetor box
cover.
:
Set Master Control lever to n –
even if engine is cold.
:
Press in button to open the
decompression valve.
:
Now start the engine.
English / USA
Operating Instructions
During break-in period
A factory new machine should not be run
at high revs (full throttle off load) for the
first three tank fillings. This avoids
unnecessary high loads during the
break-in period. As all moving parts
have to bed in during the break-in
period, the frictional resistances in the
engine are greater during this period.
The engine develops its maximum
power after about 5 to 15 tank fillings.
Do not make the mixture leaner to
achieve an apparent increase in
power – this could damage the
engine – see "Adjusting
Carburetor".
Always disengage the chain brake
before opening the throttle. Running
the engine at higher revs with the
chain brake engaged (saw chain at
a standstill) will quickly damage the
engine and chain drive (clutch,
chain brake).
41
