Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
Problem
Tool does not work.
The tool stops working
during operation.
During operation the
LED work light rapidly
flashes.
During operation the
LED work light flashes
more slowly.
The battery/torque
indicator does not flash
during charging.
During charging the
middle battery/torque
indicator LED goes off,
the other two LEDs
flash simultaneously.
Bit cannot be installed.
16
Cause
1. The built-in battery
charge is depleted.
2. The tool is locked.
3. The tool is being
charged.
1. The built-in battery
charge is depleted.
2. The torque setting is
insufficient.
The tool becomes
overloaded or too hot.
The battery charge is
low.
1. Wrong USB-C
charging cable used.
2. The built-in battery is
damaged.
3. Surrounding air
temperature is too
hot or too cold.
The built-in battery is
briefly
over-temperature.
Bit does not fit the 1/4''
hex bit holder.
Remedy
1. Charge the tool.
2. Unlock the tool by
pressing the lock-off
button until the lock-off
indicator goes off.
3. Disconnect the USB-C
power cable for the tool.
1. Charge the tool.
2. Increase the torque
setting.
Rest the tool for a while or
place the tool under airflow
for cooling.
Charge the tool.
1. Use only included USB-C
charging cable or other
certificated USB charging
cables.
2. Have the tool serviced
by an Authorized SKIL
Service Station.
3. Move the tool to an
environment with
appropriate temperature
for charging.
This is normal. The tool
will automatically resume
charging after a period of
time.
Use suitable bit or adaptor.
