Idiomas disponibles
Idiomas disponibles
Changing the Angle of the Pivot
Head (Fig. 6)
The pivot head can be placed into one of
the three working positions: 0°, 22.5°,
and 45°.
1. While pressing the pivot-head release
button, rotate the pivot head to switch
between the three positions.
2. Release the release button. An audible
click indicates that the pivot head is
locked in place.
Installing/Removing a Bit (Fig. 7)
WARNING
starting that may result in possibly
serious injury, always lock-off the tool
when installing or removing bits.
- Insert a bit into the magnetic bit holder.
The magnetized holder will secure the
bit in place (Fig. 7).
- To remove the bit, pull it out of the
magnetic bit holder.
WARNING
Installing a Bit with Hex Shank Bit
Extension (Fig. 8)
WARNING
starting that may result in possibly
serious injury, always lock-off the tool
when installing or removing bits.
1. Insert the hex shank bit extension
into the magnetic bit holder. The
magnetized holder will secure the hex
shank bit extension in place.
2. Insert a bit into the hex shank bit extension.
Tips
NOTICE:
• Always use the correct type and size of bit for the application.
• Drill a pilot hole when driving fastener in hard wood, or at or near the cross cut
end or an edge of wood, in order to avoid cracking of the wood.
To prevent
unintentional
Risk of injury! The bit may be hot after prolonged use.
Allow the bit to cool or use gloves to remove it.
To prevent
unintentional
Fig. 6
Pivot Head
22.5°
b
45°
Fig. 7
Fig. 8
Pivot-head Release
Button
Hex Shank Bit
Extension
a
13
