Idiomas disponibles
Idiomas disponibles
SYMBOLS
Safety Symbols
The purpose of safety symbols is to attract your attention to possible dangers.
The safety symbols and the explanations with them deserve your careful attention
and understanding. The symbol warnings do not, by themselves, eliminate any
danger. The instructions and warnings they give are no substitutes for proper
accident prevention measures.
WARNING
" DANGER ," " WARNING ," and " CAUTION " before using this tool. Failure to
following all instructions listed below may result in electric shock, fire, and/or
serious personal injury.
The definitions below describe the level of severity for each signal word.
Please read the manual and pay attention to these symbols.
DANGER
WARNING
CAUTION
Damage Prevention and Information Messages
These inform the user of important information and/or instructions that could
lead to equipment or other property damage if they are not followed. Each
message is preceded by the word "NOTICE", as in the example below:
NOTICE: Equipment and/or property damage may result if these instructions are
not followed.
Be sure to read and understand all safety instructions in this
Owner's Manual, including all safety alert symbols such as
This is the safety alert symbol. It is used to alert you
to potential personal injury hazards. Obey all safety
messages that follow this symbol to avoid possible
injury or death.
DANGER indicates a hazardous situation which, if
not avoided, will result in death or serious injury.
WARNING indicates a hazardous situation which, if
not avoided, could result in death or serious injury.
CAUTION, used with the safety alert symbol,
indicates a hazardous situation which, if not
avoided, will result in minor or moderate injury.
WARNING
into your eyes, which can result in severe eye damage. Before
beginning power tool operation, always wear safety goggles
or safety glasses with side shields and a full face shield when
needed. We recommend a Wide Vision Safety Mask for use
over eyeglasses or standard safety glasses with side shields.
Always use eye protection which is marked to comply with
ANSI Z87.1.
The operation of any power tools can
result in foreign objects being thrown
7
