Idiomas disponibles
Idiomas disponibles
• Only apply the tool to the fastener when the tool is switched off. Rotating bits
can slip off and damage the fastener head.
• It is recommended to perform the first few turns manually by hand, key, or a
screwdriver to ensure the correct driving of a fastener.
• In case of working with threaded components, do not exert too much pressure
on the tool. This can lead to the damage of the thread.
• Always hold the tool bit perpendicularly aligned with the fastener (Fig. 9).
Holding it at an angle may cause slipping or jamming of the fastener.
Driving and Removing Screws
(Fig. 9)
1. Select and install a suitable bit.
2. Adjust the pivot head to a desired
angle.
3. Unlock the tool by pressing the lock-
off button until the lock-off indicator
goes off.
4. Apply just enough pressure to keep
the bit engaged on the screw.
5. Press the front half of the forward/
reverse switch to drive screws in. Press the rear half of the forward/reverse
switch to remove/loosen screws.
6. If the tool stops before a screw is completely driven in, increase the torque
setting (see chapter " Setting the Torque ") or finish driving the screw
manually (see chapter " Automatic Spindle Lock ").
Automatic Spindle Lock
The automatic spindle lock allows you to use the screwdriver as a manual
screwdriver. You can give an extra twist to firmly tighten a screw, loosen a very
tight screw, or continue working when the battery charge is depleted.
14
Fig. 9
