To Stop The Product; To Use The Throttle Control - Husqvarna ST 327 Manual De Usuario

1. To engage the auger blades, push the auger
engagement (A) to the handle to engage the
auger and throw snow.
2. Raise the drive speed control lever (B) from the
middle position to make the product move
forward when the drive engagement (C) is
engaged. Do not change the speed when the
drive lever is engaged. This can cause damage
to the transmission.
3. Lower the drive speed control lever from the
middle position to make the product move
rearward when the drive engagement is
engaged.
C
4. To make the product move in the selected
direction, hold the drive engagement (C) against
the handle .
5. If the product has power steering, hold the left
steering trigger (D) to turn left. Hold the right
steering trigger to turn right.
14
A
B
D

To stop the product

1. Move the throttle control (A) to the STOP
position.
A
2. Remove the ON/OFF key.

To use the throttle control

• Slide the throttle control (A) to change the
amount of fuel used. Always operate the engine
at full throttle.
A
1674 - 004 - 18.05.2021