Husqvarna ST 327 Manual De Usuario página 12

2. To adjust the snow throwing distance of the
chute deflector, move the deflector remote
control lever (B) down to decrease the distance
and up to increase the distance.
B
To start the engine, manual start
1. Insert the ON/OFF key (A) into the ignition slot
until it clicks. Do not turn the key.
A
E
C
D
B
F
2. Slide the fuel control lever (B) to the ON position.
3. Put the throttle control (C) to the FAST position.
a) If the engine is cold, slide the choke lever (D)
to the FULL position and push the primer (E)
three times.
CAUTION:
prime the engine. It can prevent
the engine from starting. If the
engine is over primed, wait a few
minutes before attempting to start
and do not push the primer.
4. Pull the starter rope handle (F).
CAUTION:
handle quickly. Move it back to the
start position slowly.
12
A
Do not over
Do not release the
Note:
If the rope starter has frozen, slowly pull
out as much rope out of the starter as possible
and release the starter rope handle. If the engine
does not start, repeat the procedure or use the
electric starter.
5. If the choke was used to start the engine, slowly
move the choke (D) to the OFF position.
6. Run the engine 2-3 minutes at idling speed
before you start to throw snow.
7. If the engine does not run as it should, turn it off.
To start the engine, electric start
WARNING:
V A.C. electric starter. Do not use the
electric starter if your house is not a 230
V A.C. three-wire grounded system.
Serious personal injury or damage to the
product could occur. The electric starter
has a three-wire power plug, and is
designed to use 230 V A.C. household
current. Make sure that your house is a
230 V A.C. three-wire grounded system.
If you are uncertain, ask a licensed
electrician.
1. Insert the ON/OFF key (A) into the ignition slot
until it clicks. Do not turn the key.
A
E
C
D
B
2. Slide the control lever (B) to the ON position.
3. Put the throttle control (C) to the FAST position.
a) If the engine is cold, slide the choke lever (D)
to the FULL position.
4. Push the primer (E) three times.
CAUTION:
the engine. It can prevent the engine
from starting. If the engine is over
primed, wait a few minutes before
The product has a 230
G
F
Do not over prime
1674 - 004 - 18.05.2021