Garland GRASS 755 SG Manual De Instrucciones página 41

Place the air lever In the normal
RUN
working positon "RUN" .
Allow the engine to warm up for a few minutes before
starting to use the machine.
6.3.2.2. STARTING WITH A HOT ENGINE
Place the machine on a flat and stable surface in
order to start it.
RUN
Place the air lever in the normal
working position "RUN"
Push the safety switch bar until it touches the upper
handle.
Place yourself behind the mower and pull the Starter
rope until the engine starts.
If after a few tries the engine does not start, follow the
instructions for starting cold-starting the engine.
6.4. STOPPING THE ENGINE
6.5. TRACTION DRIVE
Press the traction handle against the handlebar, as
shown in the figure, and the mower traction will start
operating.
.
Turn of the engine by
releasing the safety switch.
6.6. CHECKPOINTS AFTER STARTING THE MACHINE
It is important to pay attention to the possible
individual parts or and the temperature of the
machine. If you detect any anomaly in the machine
immediately stop and check it carefully.
In case of any malfunction or problem take the
machine to a service technician to be repaired.
Under no circumstances must you continue to use the
machine if the operation does not seem appropriate.
Do not use the machine if it is damaged or improperly
adjusted.
7. USING THE MACHINE
Use this machine only for the designated
purposes. Using this chainsaw for any other use is
dangerous and can cause bodily harm and/or damage
to the machine.
Do not start the machine in a room or enclosure.
The exhaust gases and fuel and oil vapors
contain carbon monoxide and harmful
chemicals. In case of a concentration of
gases produced by poor ventilation, remove all that
impedes the flow of clean air to improve ventilation
from the work area and not return to work in the area
unless you have properly ventilated area and have
41/160
English