Idiomas disponibles
Idiomas disponibles
• Gouging at start – as caused by the edge of one or all blades not
protruding enough in relation to the surface of the rear base
(Fig. V).
• Gouging at end – as caused by the edge of one or all blades
protruding too far in relation to the surface of the rear base
(Fig. VI).
(a) Movable Front Base (11) which is altered by the Depth
Adjustment Knob (12)
(b) Fixed Rear Base (6)
Drive belt replacement
1. Replace the drive belt by first taking out the three cross-head
screws that secure the Drive Belt Cover (8) on the left-hand side
of the planer when viewed from the rear (Image N)
Note: The front screw is longer than the other two. Take care to
replace this screw in the same hole when replacing the cover.
2. Remove the damaged belt by pulling it sideways off the top
pulley and turning the bottom pulley by hand. Use a soft brush
to clean the pulleys and the surrounding area
Note: Wear eye protection when cleaning out the pulley area.
3. With the six continuous 'v' profiles on the inside, place the new
belt over the bottom pulley. Half-fit the other end of the belt
on the top pulley, then roll the belt in place whilst turning the
pulley
4. Check the belt runs evenly by manually turning the belt
5. Replace the Drive Belt Cover and the three fixing screws,
ensuring the longer screw is located in the hole at the front of
the cover
6. Plug the machine back into the power outlet and switch the tool
on and run for a minute to make sure that the motor and belt
are operating correctly
Brushes
• Over time the carbon brushes inside the motor may become
worn
• Excessively worn brushes may cause loss of power, intermittent
failure, or visible sparking
• If you suspect that the brushes may be worn, have them
replaced at an authorised service centre
EN
10
982168_OwnerManual.indd 10
982168_OwnerManual.indd 10
Contact
For technical or repair service advice, please contact the helpline on
(+44) 1935 382 222
Web: tritontools.com/en-GB/Support
UK Address:
Toolstream Ltd.
Boundary Way
Lufton Trading Estate
Yeovil, Somerset
BA22 8HZ, United Kingdom
EU Address:
Toolstream B.V.
De Keten
00004
5651 GJ
Eindhoven, Netherlands
Storage
• Store this tool carefully in a secure, dry place out of the reach of
children
Disposal
Always adhere to national regulations when disposing of power
tools that are no longer functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and
electronic equipment (WEEE), with household waste
• Contact your local waste disposal authority for information on the
correct way to dispose of power tools
21/11/2022 08:13
21/11/2022 08:13
