Idiomas disponibles
Idiomas disponibles
FOR MORE SERIOUS OR PERSISTENT PROBLEMS, CONTACT A D
SYMPTOM
Lack of power; slow to cycle
Skipping fasteners; intermittent feed
TROUBLESHOOTING GUIDE
MANY COMMON PROBLEMS CAN BE SOLVED EASILY BY UTILIZING THE CHART BELOW.
WARNING: To reduce the risk of serious personal injury, remove
fasteners from magazine before making any adjustments or servicing this tool.
CAUSE
Broken cylinder cap spring
Rings/seals cut or cracked
Exhaust blocked
Trigger assembly worn/leaks
Dirt/tar build up on driver
Cylinder sleeve not seated correctly on bottom bumper
Air pressure too low
Worn bumper
Debris in nose, door, contact arm area
Air restriction/inadequate air flow through quick disconnect socket and
plug
Worn piston ring
Damaged pusher spring
Low air pressure
Loose magazine nose screws
Fasteners too short for tool
Bent fasteners
Wrong size fasteners
Leaking head cap gasket
Trigger valve O-ring cut/worn
Broken/chipped driver
Dry/dirty magazine
Worn magazine
WALT SERVICE CENTER OR CALL 1-(800)-4-D
e
FIX
Replace cap spring
Replace rings/seals
Check bumper, head valve spring
Replace trigger assembly
Disassemble nose/driver to clean
Disassemble to correct
Check air supply equipment
Replace bumper
Clean nose, door, contact arm area
Replace quick disconnect fittings
Replace ring, check driver
Replace spring
Check air supply system to tool
Tighten all screws
Use only recommended fasteners
Discontinue using these fasteners
Use only recommended fasteners
Tighten screws/replace gasket
Replace O-ring
Replace driver (check piston ring)
Clean
Replace magazine
13
WALT.
e
