Setting The Hdmi Control Function; Registering Hdmi Components To Tv; Changing The Connection Method And Connected Components - Yamaha YRS-700 Manual De Instrucciones

Setting the HDMI control function

1
Turn on all components connected to this
unit with HDMI.
2
Check all components connected with
HDMI and enable the HDMI control
function on each component.
For this unit, set "HDMI Ctrl" to "On" (☞p. 21).
For external components, refer to the manual supplied
3)
with each component.
3
Turn off the TV and then turn on it again.

Registering HDMI components to TV

1
Select this unit as the input source for the
TV.
2
Turn on the HDMI control function
supported component (example: Blu-ray
disc player) connected to this unit.
3
Select the input source of this unit to Blu-
ray disc player and check whether the
image in the player is correctly displayed
or not.
When connecting Blu-ray disc player with HDMI 1 jack,
press input selector key once to show the following
diagram.
Input source name
HDMI1
y
2)
• The default setting is "Off".
When "HDMI Ctrl" is set to "On" in setup menu,
– Even you press key, the power does not completely turned
off and the signal outputs from the HDMI IN jack to HDMI OUT
(ARC) jack.
– Before pressing key, select desired input sources connected
to HDMI IN (1 to 3).
– According to the TV, the TV operation such as changing the
channel may change the setting of surround modes of this unit.
4
Check if the HDMI control function works
(turn on this unit or adjust the volume level
using the remote control of the TV).
If the HDMI control function is not working
Check the following:
– The TV is connected to the HDMI OUT (ARC) jack of this
unit.
2)
– "HDMI Ctrl" (☞p. 21) is set to "On" in setup menu.
– The HDMI control function is enabled on the TV. (Also
check the relative settings such as power interlock function
or speaker priority.)
The HDMI control function is not working even checking the
above,
– Turn off this unit and the TV, and then turn them back on
4)
again.
– Unplug the power cables of the TV and this unit, and plug
them in again.
– After selecting INPUT1, INPUT2, INPUT3 or DOCK,
change the input of TV and the one of this unit to the same
input.
Changing the connection method and
connected components
When the connected components and jacks are changed, reset this
unit with following procedures.
1
Turn off the HDMI control function of the
TV and player, turn off all connected
devices, and change the connections.
2
Perform the step 1 to 3 of "Setting the
HDMI control function" (☞p. 9).
y
3)
The example of TV settings
• From a setup menu on your TV, select "Link setting"
control setting" (example), then set a setting such as "HDMI control
function" to "On" (example).
• Setting such as "Speaker priority" should be set to "AV amplifier".
y
4)
For some HDMI components, you only need to set the HDMI control
function. Registering HDMI components to TV is not required in this
case.
Initial settings
"HDMI
9
En