Parkside PMRA 20-Li A1 Traduccion Del Manual De Instrucciones Originale página 58

GB MT
Spot mode / fi xed point
mowing
This function allows you to mow lawns that
are otherwise covered by seating furniture,
playground equipment or similar.
1. Place the mower on the target area of
the lawn.
2. If necessary, open the cover (1).
3. Unlock the display (10) with the 4-digit
PIN (factory setting "1111").
4. Press the OK button (7) to enter the
main menu.
5. Select "Spot mode" with the arrow but-
tons (6).
The display shows "Close the cover to
start".
6. Close the cover (1) and the mower
starts mowing with the fi xed point.
The lawn mower mows in an anti-
clockwise spiral direction and
switches to "Automatic mowing" after a
mowing radius of 1 m or 3.5 minutes of
mowing.
If the mower encounters an obstacle, the
mower stops, the display indicates that
mowing has stopped and the mower
switches to standby mode.
When the lawn mower hits the boundary
wire (11), it continues mowing in the oppo-
site spiral direction.
If the mower is outside the bounda-
ry wire (11) or on the charging sta-
tion and you select "Spot mode", the dis-
play shows "Please place inside the
boundary and try again". Set the mower
down inside the boundary wire (11) and
next to the charging station and restart
"Spot mode".
58
If the battery charge level is less
than 30 %, the display shows "Low
battery voltage" after 2 seconds. Charge
the lawn mower before you can start mow-
ing with the fi xed point.
Setting the date and time
1. If necessary, open the cover (1).
2. Unlock the display (10) with the 4-digit
PIN (factory setting "1111").
3. Press the OK button (7) to enter the
main menu.
4. Use the arrow buttons (6) to select "Set-
tings".
5. Confi rm the selection with the OK but-
ton (7).
6. Use the arrow buttons (6) to select
"Date and time".
7. Confi rm the selection with the OK but-
ton (7).
8. Change the date and time with the
arrow buttons (6). The individual po-
sitions can be navigated with the OK
button (7) (skip the right).
The correct date and time setting is
required to ensure the correct func-
tion of the operating time settings.
Setting the rain sensor
Never operate the lawn
mower during storms and
make sure to disconnect the charg-
ing station from the mains.
If the rain sensor is switched on, the lawn
mower returns to the charging station when
it rains.
1. If necessary, open the cover (1).
2. Unlock the display (10) with the 4-digit
PIN (factory setting "1111").