Idiomas disponibles
Idiomas disponibles
English
Fig. F2
Using Template Guides
The round subbase will accept universal template guides.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center.
nOTE: The D-shape subbase does not accommodate
template guides and is designed to accommodate bits up
to 1-3/8" (34.9 mm) in diameter.
To Use Template guides:
1. Center the subbase. See Centering The Subbase.
2. Install template guide (available as an accessory) on the
subbase and tighten securely.
Installing a Fixed Base Edge Guide (Fig. G)
(Included with some models)
An edge guide (model DNP618) for your fixed base is
available from your local retailer or service center at
extra cost.
1. Remove the motor from the fixed base. Refer to
Removing the Motor from the Fixed Base.
2. Remove flat head screws
edge guide.
3. Slide edge guide
25
of fixed base (Fig. G). Insert the two flat head screws
through the appropriate holes in the subbase to secure
the edge guide. Tighten hardware.
4. Follow all instructions included with the edge guide.
nOTE: To remove the edge guide, reverse the above
procedure. After removing edge guide, always replace the
two flat head screws into the storage holes on the edge
guide to prevent loss.
10
from storage holes on
26
into edge guide slot
27
Fig. G
25
24
Using a Premium Edge Guide
(Plunge Base Only)
(Included with some models)
A Premium Edge Guide (model DW6913) is available from
your local retailer or service center at extra cost. Follow the
assembly instructions included with the edge guide.
Installing a Plunge Base Edge Guide with
Guide Rods (Fig. H)
(Included with some models)
An edge guide (model DW6913) for your plunge base
is available from your local retailer or service center at
extra cost.
1. Attach the guide rods
2. Attach the thumb screws
the base.
3. Tighten the thumb screws
4. Slide the edge guide
5. Attach thumb screws
edge guide.
6. Tighten the thumb screws temporarily. Refer to
Adjusting the Edge Guide.
Adjusting the Edge Guide (Fig. A, H)
Follow the assembly instructions included with the
edge guide.
1. Draw a cutting line on the material.
2. Lower the router carriage until the cutter is in contact
with the workpiece.
3. Lock the plunge mechanism by releasing the plunge
lock lever
4. Position the router on the cutting line. The outer cutting
edge of the cutter must coincide with the cutting line.
5. Slide the edge guide
on side
tighten the thumb screws
26
35
to the plunge router base.
36
and springs
.
36
38
over the rods.
and springs
36
16
38
against the workpiece and
36
.
27
37
to
to the
37
