Idiomas disponibles
Idiomas disponibles
Cleaning
DANGER! ELECTRIC SHOCK!
Before starting to clean the blender and its components:
►
Ensure that the motor is switched off and the power plug removed from the
socket.
Do not immerse the motor block 6 in water or other liquids. This could
result in you receiving a fatal electric shock and cause damage to the
appliance.
►
Never open the housing of the appliance. Otherwise, there is a risk of a
fatal electric shock.
WARNING! RISK OF INJURY!
Handle the cutting blades 4 with extreme caution. They are very sharp.
►
CAUTION! PROPERTY DAMAGE!
►
Do not use solvents or abrasive cleaners on the plastic surfaces, they could
be damaged by them.
Cleaning the blender
To prevent injuring yourself on the cutting blades 4, clean the blender 3 only
■
with a long-handled washing-up brush.
Clean the measuring cap 1 and the lid 2 in mild soap solution. Ensure that
■
the rubber seal 9 is correctly fitted before using the lid 2 again.
NOTE
■
If you clean the appliance directly after use, you can usually achieve
sufficiently hygienic cleaning results by using the following alternatives:
Fill the blender 3 with 750 ml of water and add a couple of drops of mild
washing up liquid. Close the lid 2 and fit the blender 3 onto the motor
block 6. Insert the mains plug into the socket and activate the pulse function
a few times so that the cutting blades 4 plough through the water at maximum
speed. Afterwards, rinse the blender 3 with plenty of clean water to remove
any washing up liquid residues.
SSTMC 600 A1
You can also clean the lid 2, the measuring cap 1 and the
blender 3 with the cutting blade 4 in your dishwasher.
GB │ MT
│
67
■
