Idiomas disponibles
Idiomas disponibles
Using the MENU / The PICTURE CTRL Menu
Using the MENU
The projector is equipped with an on-screen menu for
making various adjustments and settings.
To select the language used in the menu, see page
26 (GB).
1
Press the MENU key.
The menu display appears.
The bar on the icon of the currently selected menu
is highlighted in yellow.
PICTURE CTRL
CONTRAST:
80
BRIGHT:
50
RGB ENHANCER: 30
GAMMA MODE: GRAPHICS
COLOR TEMP: LOW
2
Use the M or m key to select a menu, then press
the , or ENTER key.
The selected menu appears.
Menus
Setting items
SET SETTING
STATUS:
ON
INPUT-A:
COMPUTER
AUTO INPUT SEL: OFF
LANGUAGE:
ENGLISH
SPEAKER:
ON
POWER SAVING: OFF
SIRCS RECEIVER: FRONT&REAR
3
Make setting or adjustment on an item.
For details on setting individual items, see the relevant
menu pages.
To clear the menu display
Press the MENU key.
The menu display disappears automatically if no key
is pressed for one minute.
To reset items that have been adjusted
Press the RESET key.
"Complete!" appears on the screen and the settings
appearing on the screen will be reset to their factory
preset values.
Items which can be reset are:
• "CONTRAST", "BRIGHT", "COLOR", "HUE",
"SHARP" and "RGB ENHANCER" in the
PICTURE CTRL menu.
• "DOT PHASE", "SIZE H" and "SHIFT" in the
INPUT SETTING menu.
22
(GB)
INPUT-A
INPUT-A
About the memory of the settings
The settings are automatically stored in the projector
memory.
When no signal is input
When there is no input signal, "NO INPUT–Cannot
adjust this item." appears on the screen, and each item
cannot be adjusted.
The PICTURE CTRL Menu
The PICTURE CTRL (control) menu is used for
adjusting the picture.
Unadjustable items depending on the input signal are
not displayed in the menu.
When the video signal is input
PICTURE CTRL
CONTRAST:
80
BRIGHT:
50
COLOR:
50
HUE:
50
SHARP:
50
D.PICTURE:
ON
COLOR TEMP: LOW
COLOR SYS: AUTO
When the RGB signal is input
PICTURE CTRL
CONTRAST:
80
BRIGHT:
50
RGB ENHANCER: 30
GAMMA MODE: GRAPHICS
COLOR TEMP: LOW
Operation
1. Select an item
Use the M or m key to select the item, then press the
, or ENTER key.
2. Adjust an item
• When changing the adjustment level:
To increase the number, press the M or , key.
VIDEO
INPUT-A
