Candy CVMAD60/1N/S Manual De Instrucciones página 11

Idiomas disponibles

MAINTENANCE AND CLEANING

Caution:

• Before maintenance or cleaning is carried out, the cooker hood should be

disconnected from the mains power supply. Ensure that the cooker hood is switched

off at the wall socket.

• External surfaces are susceptible to scratches and abrasions, so please follow the

cleaning instructions to ensure the best possible result is achieved without damage.

GENERAL

Cleaning and maintenance should be carried out with the appliance cold especially

when cleaning.Avoid leaving alkaline or acid substances (lemon juice, vinegar etc.) on

the surfaces.

STAINLESS STEEL

The stainless steel must be cleaned regularly (e.g.weekly) to ensure a long life

expectancy.Dry with a clean soft cloth. A specialized stainless steel cleaning fluid may

be used.

NOTE:

Ensure that wiping is done along with the grain of the stainless steel to prevent any

unsightly crisscross scratching patterns from appearing.

CONTROL PANEL SURFACE

The inlay control panel can be cleaned using warm soapy water. Ensure the cloth is

clean and well wrung before cleaning. Use a dry soft cloth to remove any excess

moisture left after cleaning.

Important

Using neutral detergents and avoid using harsh cleaning chemicals, strong household

detergents or products containing abrasives,as this will affect the appearance of the

appliance and potentially remove any printing of artwork on the control panel and will

void manufactures warrantee.

GREASE MESH FILTERS

The mesh filters can be cleaned by hand. Soak them for about

3 minute in water with a mild detergent and then brush it gently

with a soft brush. Please do not apply too much pressure so as

to avoid any damage to it . (Leave to dry naturally out of direct

sun light)

Filters should be washed separately to crockery and kitchen

utensils. It is advisable not to use rinse aid.

INSTALLING GREASE MESH FILTERS

• To install filters for the following four steps:

- Angle the filter into the slots at the back of the hood.

- Push the button on the handle of the filter.