Candy CVMAD60/1N/S Manual De Instrucciones página 10

Start Using Your Cooker Hood
Push button
a. Push the stop button, and the motor will stop.
b. Push the low button, and the motor will run at low speed.
c. Push the middle button, and the motor will run at mid speed.
d. Push the high button, and the motor will run at high speed.
e. Push the lamp button and the two lights will illuminate. Push it again and the light
will turn off.
TROUBLESHOOTING
Fault
Light on, but motor
does not work
Light does not
work, motor does
not work
Oil leakage
Lights not working
Insufficient suction
The Cooker hood
inclines
NOTE:
Any electrical repairs to this appliance must conform to your local, state and
federal laws. Please contact the service centre if in any doubt before
undertaking any of the above. Always disconnect the unit from the power source when
opening the unit.
Stop Low Mid
Possible Cause
Fan switch turned off
Fan switch failed
Motor failed
House fuses blown
Mains power cable is loose or
disconnected
One way valve and the outlet
are not tightly sealed
Leakage from the connection of
chimney and cover
Broken or faulty bulbs
The distance between the
cooker hood and the gas top is
too far
The fixing screw is not tight
enough
High Lamp

Select a fan switch position.
Contact service center.
Contact service center.
Reset/Replace fuses.
Refit mains power cable to
power outlet.
Switch power outlet on.
Take down the one way valve
and seal with sealant.
Take chimney down and seal.
Replace blubs as per this
instruction.
Refit the cooker hood to the
correct distance.
Tighten the hanging screw and
make it horizontal.
9
Solution