Idiomas disponibles
Idiomas disponibles
Assembly
• Slide the handle into the base of the
vacuum as shown in Figure A.
A
• Fasten the two parts together with the
supplied screw as shown in Figure B.
Ensure vacuum is assembled securely.
B
• Slide the nozzle (3) of the hand vac into
the bottom of the chassis (15) and push
the vac fully into the chassis until you hear
a snap as shown in Figure C.
• To remove, depress the hand vac release
button (14) and pull the hand vac out.
C
Attaching extended reach tool
• Slide the nozzle (3) into the extended
reach tool (18) as shown in Figure D.
• To remove the floor extension tube,
depress the floor extension release button
(17) and pull the tube off of the vacuum.
D
• A flip-up brush (20) is built into the
extended reach tool (18) and can be
flipped upwards for use as shown in
Figure E.
E
Charging the battery
• Before first use, the battery must be
charged for at least 4 hours.
• Plug the jack plug of the charger into
the charging socket of the tool as shown
in Figure F. Plug the charger into any
standard 120 Volt 60 Hz electrical outlet.
WARNING:
to empty all contents and dry thoroughly if
needed to avoid damage to your appliance.
NOTE: While charging, the charger may
become warm. This is normal and does not
indicate a problem. The appliance can be
left connected to the charger indefinitely.
WARNING:
battery at ambient temperatures below 50 °F
or above 104 °F.
F
4
Before charging, be sure
Do not charge the
