Idiomas disponibles
Idiomas disponibles
7.
OSD Settings
There is a small joystick in the camera cable that allows you to adjust the
settings of the camera using an on-screen display (OSD).
In the OSD menu:
NEXT/BACK: select this option and press the middle button to go to the
next/previous page of options in the menu.
RETURN: select this option and press the middle button to return to the
previous level in the menu.
EXIT: select this option and press the middle button to leave the OSD
menu without saving the settings.
SAVE ALL: select this option and press the middle button to save all
settings.
CAMERA RESET: select this option and press the middle button to reset
the camera to the factory defaults.
The OSD menu settings are described in detail below.
7.1
Lens
The LENS menu is not applicable to this camera. You can leave the settings
as they are.
7.2
Shutter/AGC
Use this menu option to control how the camera responds to high and low
light settings using auto-gain and shutter settings. You can choose
automatic or manual control. Automatic control is usually sufficient for most
environments.
Display: SHUTTER/AGC
AUTO
MODE = SHUT: the camera adjusts the image by changing
SETUP
the shutter speed. You can configure high and low luminance
conditions.
HIGH LUMINANCE: use this to adjust bright images.
Note: if you adjust this setting, we recommend that you do it
when there is a lot of light available.
V. 01 – 13/06/2013
CAMCOLBUL28Z
Press the middle button to access the menu, or to
select an option.
Press the up and down buttons to move up and
down in the menu.
Press the left and right buttons to modify the menu
parameters.
BRIGHTNESS: Set the brightness level for high luminance
mode. Default setting is 24.
5
©Velleman nv
