Velleman CAMCOLBUL28Z Manual Del Usuario página 10


Remarks:


7.10 Noise reduction
Use this function to set the noise reduction mode.
Display: NR
OFF Noise reduction is switched off.
Y Use only luminance (Y) noise reduction.
C Use only colour (C) noise reduction.
Y/C Use both luminance (Y) and colour (C) noise reduction
(recommended setting).
Set Y LEVEL for luminance and C LEVEL for colour noise reduction.
7.11 Camera ID
Use this function to give the camera a name. The name will appear on the
monitor. You can define where the name appears on the screen.
Display: CAMERA ID
OFF No name for the camera.
ON You can enter two lines of 26 characters for the camera name.
Note: make sure that CHR1 is selected.

Position the cursor in the text line by selecting the arrow icons
 on the OSD screen.

Use the navigation buttons on the joystick to select the
characters for the name. Press the middle button to confirm and
move to the next character.

Select CLR to delete a character.

Select POS to position the name on the monitor. Use the
navigation buttons on the joystick to move the text to the
desired position, and press the middle button to confirm.
V. 01 – 13/06/2013
CAMCOLBUL28Z
to switch to night mode. Recommended settings are 40-75
for indoors, and 150 for outdoors.
NIGHTDAY: sets the threshold for switching from night to
day mode. The higher the setting, the more light is required
to switch to day mode. Recommended settings are 50-85 for
indoors, and 175 for outdoors.
The DAY>NIGHT setting must always be lower than the
NIGHT>DAY setting.
Make sure that the difference between the two settings is
large enough. If the settings are too close together, the
camera will switch too often between the two modes.
10 ©Velleman nv