Maintenance - Urrea SS950 Manual De Usuario

Cutting oil will keep the blade cool, increase
cutting action, and prolong blade life.
WARNING: Never use gasoline, because nor-
mal sparking could ignite the fumes.
1. Securely clamp the workpiece in position,
and make the cut close to the clamping point
in order to minimize vibration of the work be-
ing cut.
2. When cutting conduit pipe or angle iron,
clamp the work in a vise, if possible, and cut
close to the vise.
3. To cut thin sheet material, "sandwich" the
material between pieces of hardboard or ply-
wood, and clamp the layers together in order
to reduce vibration and tearing of the mate-
rial.

MAINTENANCE

IMPORTANT: Inspect the reciprocating saw,
the on/off switch, and the cord for damage be-
fore each use. Check for damaged, missing, or
worn parts.
CAUTION: Be sure to switch power OFF and
disconnect the plug from the receptacle during
maintenance and inspection. Using cracked,
deformed or damaged parts can result in seri-
ous personal injury.
The brushes are designed to give you several
years of use. If they ever need replaced follow
the instructions in this manual or return the
tool to the nearest service center for repair.
INSPECTING THE SCREWS
Check for loose screws, misalignment or bind-
ing of moving parts, or any other condition
that may affect the operation of the recipro-
cating saw. If abnormal vibration or noise oc-
curs, turn the reciprocating saw off immedi-
ately, and have the problem corrected before
further use.
Using compressed air may be the most effective
cleaning method. Always wear safety goggles
when cleaning tools using compressed air.
E N G L I S H •
INSPECTING THE CARBON BRUSHES
The motor employs carbon brushes which are
consumable parts. Replace the carbon brush
with a new one when it becomes worn to its
wear limit.
Always keep carbon brushes clean and ensure
that they slide freely within the brush holders.
Using this reciprocating saw with a carbon
brush which is worn in excess of the wear limit
will damage the motor.
REPLACING CARBON BRUSHES
Remove the brush caps and carbon brushes.
After replacing the carbon brushes, do not
forget to tighten the brush caps securely.
WARNING: Do not let brake fluid; gasoline,
petroleum-based products, penetrating oil,
etc. come into contact with plastic parts. These
substances contain chemicals that can damage,
weaken, or destroy plastic.
WARNING: When servicing, use only iden-
tical replacement parts. The use of any other
parts may create a hazard or cause damage to
the product.
WARNING: Use only accessories that are rec-
ommended for this reciprocating saw by the
manufacturer.
Accessories that may be suitable for one tool
may become hazardous when used with an-
other tool.
WARNING: Use only accessories that are
recommended by the manufacturer for your
model. Accessories that may be suitable for
one tool may become hazardous when used
on another tool.
WARNING: Maintain tools with care. Keep
cutting tools sharp and clean. Properly main-
tained tools with sharp cutting edges are less
likely to bind, and are easier to control.
WARNING: In order to ensure safety and re-
liability, all repairs should be performed by a
qualified service technician.
U se r's m a n ua l
13