Adjusting The Miter Angle - Makita M2300 Manual De Instrucciones

Sierra de inglete mixta
Ocultar thumbs Ver también para M2300:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Kerf board
This tool is provided with the kerf board in the turn base
to minimize tearing on the exit side of a cut. If the kerf
groove has not yet been cut in the kerf board by the
factory, you should cut the groove before actually using
the tool to cut a workpiece. Switch on the tool and lower
the blade gently to cut a groove in the kerf board.
Fig.9
► 1. Kerf board
Maintaining maximum cutting
capacity
This tool is factory adjusted to provide the maximum
cutting capacity for a 255 mm (10") saw blade.
When installing a new blade, always check the lower limit
position of the blade and if necessary, adjust it as follows:
First, unplug the tool. Lower the handle completely. Use
the wrench to turn the adjusting bolt until the periphery
of the blade extends slightly below the top surface of
the turn base at the point where the front face of the
guide fence meets the top surface of the turn base.
1
Fig.10
► 1. Adjusting bolt
With the tool unplugged, rotate the blade by hand while
holding the handle all the way down to be sure that
the blade does not contact any part of the lower base.
Re-adjust slightly, if necessary.
1
Fig.11
► 1. Top surface of turn base 2. Periphery of blade 3. Guide fence
CAUTION:
1
always be sure that the blade does not contact
any part of the lower base when the handle is
lowered completely. Always do this with the tool
unplugged.

Adjusting the miter angle

Fig.12
► 1. Lock lever 2. Grip
Loosen the grip by turning counterclockwise. Turn the
turn base while pressing down the lock lever. When you
have moved the grip to the position where the pointer
points to the desired angle on the miter scale, securely
tighten the grip clockwise.
CAUTION:
sure to raise the handle fully.
CAUTION:
always secure the turn base by tightening the grip
firmly.
6 ENGLISH
2
130mm(5-1/8")
After installing a new blade,
2
When turning the turn base, be
After changing the miter angle,
3
1
Tabla de contenido
loading

Tabla de contenido