Sony HT-MT500 Manual De Instrucciones página 52

[Auto]: The data transfer rate is
automatically changed depending on
the environment. If audio playback is
unstable in this mode, use the other
three modes.
[Sound Quality]: The highest bit rate is
used. Sound is sent in a higher quality;
however, audio playback sometimes
may become unstable when the link
quality is not good enough.
[Standard]: The middle bit rate is used. It
balances both sound quality and
playback stability.
[Connection]: Stability is prioritized.
Sound quality may be reasonable and
connection status will most likely be
stable. If the connection is unstable, this
setting is recommended.
[Wireless Surround
Settings]
This setting is for using wireless
speakers (not supplied) as the surround
speakers of the system. For details, see
"Adding Rear Speakers (Wireless
Surround)" (page 37).
[System Settings]
[OSD Language]
You can select the language you want
for the system on-screen display.
[Wireless Subwoofer Connection]
You can perform wireless connection of
the subwoofer again. For details, see
"Performing the Wireless Connection of
the Subwoofer (SECURE LINK)"
(page 41).
[IR-Repeater]
[On]: Remote signals for the TV are sent
from the rear of the main unit (page 45).
[Off]: Turns off the function.
52
US
For details, see "Sending the Remote
Signal to the TV via the Main Unit"
(page 45).
[HDMI Settings]
• [Control for HDMI] (page 46)
[On]: The Control for HDMI function is
enabled. Devices connected with an
HDMI cable can control each other.
[Off]: Off
• [Standby Linked to TV] (page 46)
This function is available when you set
[Control for HDMI] to [On].
[Auto]
: If the input of the system is
[TV], the system turns off
automatically when you turn off the
TV.
[On]: The system turns off
automatically when you turn off the TV
regardless of the input.
[Off]: The system does not turn off
when you turn off the TV.
• [TV Audio Input Mode] (page 46)
Set this function when the system is
connected to a TV's HDMI IN jack that
is compatible with Audio Return
Channel. The Audio Return Channel
function is available when you set
[Control for HDMI] to [On].
[Auto]: You can listen to TV sound
from the speakers of the system.
[Optical]: Use this setting when an
optical digital cable is connected.
[Quick Start/Network Standby]
[On]: Shortens the startup time from
standby mode. You can operate the
system quickly after turning it on.
[Off]: Off
[Auto Standby]
[On]: Turns on the [Auto Standby]
function. When you do not operate the
system for about 20 minutes, the
system enters standby mode
automatically.
[Off]: Off