Replacing Fuses; Troubleshooting - ACTEON Satelec Piezotome Solo Manual De Uso

12.3 REPLACING FUSES

Your device is protected by two fuses in the mains
connector (Fig. 2-1).
To replace these fuses, follow the steps below:
- Switch off the device (position O).
- Disconnect the mains power cable from the electrical
network.
- Disconnect the mains power cable from the mains
connector (Fig. 2-1).
- Insert the tip of a Á athead screwdriver into the
notch located above the fuse holder to release it.
- Remove the used fuses.
- Replace the used fuses with fuses of the same type
and the same amperage.
- Place the fuse holder in its recess by pushing it until
you hear a click conÀ rming it is correctly installed.
- Connect the mains power cable to the mains (Fig.
2-1).
- Connect the mains power cable to the electrical
network.
Note:
The device also has an internal fuse not accessible
to the user. Contact SATELEC after-sales service (see
Chapter 2 - Repairs). All the information necessary for
the repair of faulty components is made available by
SATELEC to the technical personnel of the SATELEC-
approved dealer network who carry out the work.

12. 4 TROUBLESHOOTING

Refer to the table below:
13