ACTEON Satelec Piezotome Solo Manual De Uso página 14

Anomalies observed
No operation (LCD screen
off)
No operation (LCD screen
on)
No spray
Unsuitable spray
Fault concerning the low
vibration power of tips
No ultrasound
Liquid leak in the irriga-
tion pump
No light
(Only on the P S
IEZOTOME
L handpiece)
ED
14
Possible causes
Faulty connection of the mains power
cable
Mains isolating switch in position O.
No mains voltage.
Fuse(s) in the mains connector not
working.
Internal fuse not working.
Transmission fault.
Pouch or bottle of irrigating solution
empty.
Irrigation deactivated.
Irrigation line blocked.
Irrigation line pinched.
Irrigation Á ow rate wrongly set.
Tip worn or distorted.
Incorrect power setting.
Incorrect use: angle of approach
incorrect or inadequate pressure on
the clinical site.
Presence of liquid or humidity on the
handpiece connector.
Tip not tight enough.
Faulty connector contact.
Handpiece cable wire cut.
Pipe ruptured in the irrigation line
cassette.
LED ring not À tted to the handpiece
Faulty LED ring
Faulty LED ring connector contacts
OLO
LED ring poles reversed
Faulty handpiece and/or cord connec-
tor contacts
Other
Solutions
Check the mains plug.
Return to the SATELEC after-sales team.
Set the mains isolating switch to position I.
Call out an electrician.
Replace the fuses in the mains connector.
Return to the SATELEC after-sales team.
Switch off the device and switch it back it.
Return to the SATELEC after-sales team.
Replace the pouch or bottle of irrigating
solution.
Increase the irrigation Á ow.
Replace the irrigation line.
Check the length of the irrigation line.
Reset the irrigation Á ow rate.
Replace the tip.
Refer to the clinical guide for further
information.
Refer to the clinical guide for further
information.
Thoroughly dry the electric contacts
Retighten the tip using the spanner.
Clean the connector contacts.
Return to the SATELEC after-sales team to
replace the cable.
Replace the irrigation line.
Fit the LED ring
Replace the LED ring
Clean the LED ring connector contacts
Position the LED ring according to the «+»
foolprooÀ ng marks.
Clean the handpiece and/or cord connector
contacts
Return to SATELEC after-sales