Servicing Irrigation Lines; Checking / Maintenance; Checking; Maintenance - ACTEON Piezotome Solo Manual De Uso

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 32

11.4 SERVICING IRRIGATION LINES

Sterile irrigation line
The disposable irrigation lines supplied by SATELEC shall be systematically disposed off after each use.
The reuse of a disposable irrigation line may result in contamination of your patients for which you are liable.
Do not attempt to resterilize disposable irrigation lines. Do not attempt to modify irrigation lines.
Sterilizable irrigation line
Refer to the instructions delivered with the equipment.
To service, clean, decontaminate and sterilize the sterilizable irrigation line, refer to the specific technical
maintenance guide.
XII - CHECKING / MAINTENANCE
Important:
In the event of an anomaly, we recommend you contact the supplier of your device. Do not contact any
other repairer who may render your device hazardous for you and your patients.

12.1 CHECKING

Check the device and its accessories regularly to detect any insulation fault or any damage. Replace if
necessary.
It is important to check the cleanliness of the ventilation grilles on the console ventilation to prevent abnormal
overheating.

12.2 MAINTENANCE

The device does not require any preventive maintenance other than the checking of accessories and frequent
cleaning/disinfection.

12.3 REPLACING FUSES

Your device is protected by two fuses in the mains connector (Fig. 2, item 1).
To replace these fuses, follow the steps below:
- Switch off the device (position O).
- Disconnect the mains power cable from the electrical network.
- Disconnect the mains power cable from the mains connector (Fig. 2, item 1).
- Insert the tip of a flathead screwdriver into the notch located above the fuse holder to release it.
- Remove the used fuses.
- Replace the used fuses with fuses of the same type and the same amperage.
- Place the fuse holder in its recess by pushing it until you hear a click confirming it is correctly installed.
- Connect the mains power cable to the mains (Fig. 2, item 1).
- Connect the mains power cable to the electrical network.
Note:
The device also has an internal fuse not accessible to the user.
Contact SATELEC after-sales service (see Chapter 2 - Repairs).
All the information necessary for the repair of faulty components is made available by SATELEC to the technical
personnel of the SATELEC-approved dealer network who carry out the work.
Piezotome Solo V6 V2
12
Tabla de contenido
loading

Tabla de contenido