Idiomas disponibles
Idiomas disponibles
OPERATION
1.Switch lock(See Fig. C)
The switch trigger can be locked in the OFF position. This
helps to reduce the possibility of accidental starting when
not in use. To lock the switch trigger, place the rotation
control in the center position.
2.Forward/reverse rotation control.
For drilling and screw driving use forward rotation marked
"
" (lever is moved to the right)(See Fig. D1).
Only use reverse rotation marked "
moved to the left) to remove screws or release a jammed
drill bit(See Fig. D2).
Warning: Never change the direction of
rotation when the chuck is rotating,
wait until it has stopped!
3.Operating the on/off switch (See Fig. E)
Depress the On/Off switch to start and release it to stop
your drill driver. The on/off switch is fitted with a brake
function which stops your chuck immediately when you
quickly release the switch.
Warning: Do not operate for long
periods at low speed because excess
heat will be produced internally.
4.Battery capacity indicator
Battery capacity indicator shows battery capacity when
using.
5.LED light (See Fig. F)
Before operation, the LED light will be activated when the
On/Off switch is slightly pressed, and will automatically
turn off 5 seconds after the On/Off switch is released.
• Overloaded: The tool is operated in a manner
that causes it to draw an abnormally high current. In
this situation, release the Trigger Switch on the tool
and stop the application that caused the tool to become
overloaded. Then pull the Trigger Switch again to restart.
• Overheated: Under the condition above, if the tool
does not start, the Tool and Battery are overheated. In this
situation, let the Tool and Battery cool before pulling the
Trigger Switch again.
• Low battery voltage: The remaining Battery
capacity is too low and the tool will not operate. In this
situation, remove and recharge the Battery.
Warning:
To turn on the light, press the On/Off switch and make
sure the Forward/Reverse Rotation Control is on right/
left position.
18
PROBLEM SOLUTION
1. WHY DOES THE DRILL NOT TURN ON
WHEN YOU PRESS THE SWITCH?
The forward/reverse rotation control, which is on top of
the trigger, is positioned in the lock function. Unlock the
forward/reverse rotation control by putting it into the
required rotation position. Push the trigger and the drill
will start to rotate.
2. REASONS FOR DIFFERENT BATTERY
" (lever is
PACK WORKING TIMES
Charging time problems, as above, and having not used a
battery pack for a prolonged time will reduce the battery
pack working time. This can be corrected after several
charge and discharge operations by charging & working
with your drill. Heavy working conditions such as large
screws into hard wood will use up the battery pack energy
faster than lighter working conditions. Do not re-charge
your battery pack below 0°C and above 40°C as this will
affect performance.
MAINTENANCE
Your tool requires no additional lubrication or
maintenance.
There are no user serviceable parts in your power tool.
Never use water or chemical cleaners to clean your power
tool. Wipe clean with a dry cloth. Always store your power
tool in a dry place. Keep the motor ventilation slots clean.
Keep all working controls free of dust. Occasionally you
may see sparks through the ventilation slots. This is
normal and will not damage your power tool.
FOR BATTERY TOOLS:
The ambient temperature range for tool and battery use
and storage is 0°C-45°C.
The recommended ambient temperature range for the
charging system during charging is 0°C-40°C.
EN
