Mafell ERIKA 70 Manual De Montaje página 15

The fence guide extension is used to fasten longer
workpieces. In addition, with the drop stop that is
included in the delivery, the fence guide extension can
also be used as length fence. The telescopic rod
extends the fence guide extension (1 m) to 1.8 m. This
also allows an extension of the length fence to 1.8 m.
The support plate at the telescopic rod is used to
support the workpiece.
Danger
Only carry out adjustments on the
fence guide extension when the
saw blade is stationary and the
mains plug has been unplugged.
4.1 Installation fence guide extension on multi-
purpose guide fence
The fence guide extension 13 (Fig. 7) is mounted on
the multi-purpose extension as follows:
•
Remove the fence extension 14 (Fig. 8).
•
First install the clamping nut 15 with the cylinder-
head screw 16 on the stop plate. The clamping
nut is additionally required to absorb the
longitudinal forces occurring when using the drop
stop.
•
Swivel the guide fence to 45° for installation.
•
When installing on the table: Slide the fence
guide extension 13 onto the guide fence until the
rear edge of the cut-out rests against the short
fence extension 14.1 (see Fig. 7). This ensures
that the scale in the fence extension matches the
saw blade at every angle setting.
When the sliding table is used, it
cannot be ensured that the scale in
the fence extension matches the
saw blade at every angle setting.
4.2 Installation
universal guide fence
The fence guide extension 13 (Fig. 7) is installed on
the universal guide fence as follows:
•
Remove the fence extension 17 (Fig. 9).
•
First install the clamping nut 15 with the cylinder-
head screw 16 on the stop plate. The clamping
nut is additionally required to absorb the
longitudinal forces occurring when using the drop
stop.
•
Slide the fence guide extension 13 (Fig. 7) onto
the guide fence.
4.3 Further application options
Stop plate and fence guide extension in conjunction
with further items from the optional accessory program
offer the following applications:
Fence guide extension as cross stop and mitre
stop:
•
The scale in the fence guide extension 13 (Fig.
10) shows an offset of 5 mm. With this offset, the
trimming dimension can be accurately set with
the drop stop 18 if the distance between fence
guide extension and saw blade is also 5 mm.
•
With the telescopic rod 19, the trimming range
can be extended to approx. 1.80 m. The support
plate 20 that is included in the delivery serves as
workpiece support.
Fence guide extension as parallel guide fence
•
The clamping device 21 (Fig. 11) offers an
additional means of fastening for the fence guide
extension. For this, introduce the clamping
device 21 at the bottom into the groove of the
fence guide extension 13 (Fig. 10) and clamp it
onto the dovetail guide.
-15-
fence guide extension on