Features - Urrea LE834 Manual De Usuario

14. WHEN sanding a large workpiece, provide
additional support at table height.
15. DO NOT sand with the workpiece unsup-
ported. Support the workpiece with the back-
stop or table. Plan your work support.
16. NEVER USE ANOTHER PERSON as additional
support for a workpiece longer or wider than
the table.
17. ALWAYS remove scrap pieces and other
objects from the table, backstop or belt before
turning the sander ON.
18. NEVER perform layout, assembly or set-up
work on the table while the sander is operat-
ing.
19. NEVER use solvents to clean plastic parts.
Solvents could dissolve or otherwise damage
the material. Use only a soft damp cloth to
clean plastic parts.
20. SHOULD any part of your sander be miss-
ing, damaged, or fail in any way, or any electri-
cal components fail to perform properly, shut
off switch and remove plug from power source
outlet. Replace missing, damaged or failed
parts before resuming operation.
21. NEVER PULL THE POWER CORD out of the
receptacle by pulling on the cord. Keep cords
away from heat, oil and sharp edges.
22. HAVE AN ELECTRICIAN REPLACE OR REPAIR
damaged or worn cords immediately.
23. This tool is not approved for use for any
material other than wood and wood products.

FEATURES

KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
IMPORTANT: Sanding operations are inher-
ently dusty. It is strongly recommended that
users use a dust-collection system when using
this belt & disc sander. The use of a mask or
respirator is still recommended even when a
dust-collection system is in use.
1. Belt work table.
2. Work table scale.
3. On/Off switch and switch key.
4. Worktable handle.
5. Work table scale.
6. Disc work table.
16
7. Miter gauge.
8. 8 in. Diameter sanding disc.
9. Worktable knob.
10. Belt worktable.
11. 4 in. width / 36 in. length sanding belt.
12. Tracking knob.
13. Dust bag.
14. Bag clamp.
15. Dust exhaust.
16. Belt tension lever.
17. Belt frame connection.
8
7
6
5
17
16
ASSEMBLY
CAUTION: To avoid injury, always keep the
plug disconnected from the power source and
the switch turned OFF until the sander is com-
pletely assembled and adjusted properly.
MOUNTING WORKTABLE ON DISC
The worktable is used with the sanding disc.
It should be used to support workpieces in all
sanding operations except inside curve applica-
tions.
1
9
2
3
4
10
12
11
15
14
13