Urrea LE834 Manual De Usuario página 17

1. Locate worktable handles (1) and washers
(2) in parts bag.
2. Place the worktable (3) onto the sander
frame, aligning the semi-circle slot (4) with the
threaded hole (5).
3. Place a washer (2) on threaded shaft of each
worktable handle (1 ), insert through semi-
circular slot (4), and tighten into threaded hole
(5). Repeat on other side of table.
4. Adjust worktable to level or to angle desired
for sanding.
CAUTION: To
avoid trapping the
workpiece or fingers
between the work-
table (1) and sanding
disc (2) , the worktable
edge should be posi-
tioned a maximum of
1/16 in. (1.6 mm) from
sanding disc plate as
shown.
MOUNTING WORKTABLE ON BELT
The worktable is used with the sanding belt.
It should be used to support workpieces in all
sanding operations except inside curve applica-
tions.
1. Loosen the inner hex screw (1), and raise the
belt bed (2) in the vertical position. Tighten the
inner hex screw (1).
E N G L I S H •
2. Locate worktable knob (3) and washer (4) in
parts bag.
3. Place the worktable (5) onto the sander
frame, aligning the semi-circle slot (6) with the
threaded hole (7).
4. Place washer (4) on threaded shaft of work-
table knob (3 ), insert through semi-circular
slot (6), and tighten into threaded hole (7).
5. Adjust worktable to level or to angle desired
for sanding.
CAUTION: To avoid trapping the workpiece
or fingers between the worktable and sanding
belt, the worktable edge should be positioned
a maximum of 1/16 in. (1.6 mm) from sanding
belt.
INSTALLING DUST EXHAUST AND DUST BAG
CAUTION: Sanding operations are inher-
ently dusty. To help minimize the amount of
dust that escapes into the surrounding air, this
sander is equipped with a dust exhaust and
dust bag. It is strongly recommended that users
attach the dust exhaust and the dust bag when
using this belt / disc sander. Use of a mask or
respirator is still recommended even when a
dust collection system is in use.
1. Raise the belt bed (1) and secure in the verti-
cal position.
2. Loosen the inner hex screw (2), attach the
dust exhaust (3) on the dust port (4) of the
sander, and tighten the inner hex screw (2).
U se r's m a n ua l
17