Tabla de contenido
Idiomas disponibles

Idiomas disponibles

loss of control.
• Keep your hands away of the motion parts.
• Always use goggles and dust mask when you
are grinding, specially when grind over your
head.
• Be careful with the sparks detached of the
disc when work. Hold the grinder such way
that the sparks fly away of you, other persons
or flammable materials.
• Don't touch the work piece immediately af-
ter of the operation, could be very hot and can
cause hurts.
THE KICKBACK
The kickback is a sudden reaction. The punc-
tured or hooked produces a quick decrease
speed rate causing loose control of the tool
which is directed towards the side which is the
operator.
The kickback is the result of an inappropri-
ate tool use or an incorrect operation. Can be
avoided following these instructions:
1. Keep a firm grip with both hands on the tool.
Position your body properly to resist the force
of kickback. The operator can control torque
reactions if the correct warnings are taken.
2. Never place your hand close to the rotating
accessory. It can cause a kickback over your
hand.
3. Never place your body on the kickback area;
the kickback will propel the tool to the oppo-
site direction of the rotation abrasive disc.
4. Use extra care when working with edges.
These tend to engage the disc.
5. Don't use the tool with cutting saws. These
produce kickback.

FEATURES

KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
2
1
3
E N G L I S H •
1. ON-OFF/LOCK-ON TRIGGER SWITCH
2. SPINDLE-LOCK BUTTON
3. SIDE HANDLE
ASSEMBLY AND ADJUSTMENTS
WARNING:
Re-
move
the
grinder
from the carton and
examine it carefully.
Do not discard the car-
ton or any packaging
material until all parts
are examined.
Installing and remov-
ing the grinding disc
To install a disc:
1. Disconnect the plug from the electrical out-
let. Make sure that the guard (1) is securely in
place.
2. Remove the outer flange (5).
3. Check that the inner flange (2) is properly
seated on the spindle. It will click into place on
the spindle, and will cause the spindle to rotate
when the inner flange is rotated.
4. Check the rated speed on the grinding disc
(4). Do not use a disc with a rated speed lower
than the speed shown on the grinder's name-
plate.
NOTE: The maximum disc thickness is 1/4" (6,5
mm), and the spindle opening is 7/8" (22,3 mm).
5. Place the disc on the spindle.
6. Replace the outer flange, with the flat side
of the flange facing the disc.
7. Press the spindle-lock button (6) in order to
prevent the spindle from moving.
8. While pressing the spindle-lock button,
tighten the threaded outer flange (5) by turn-
ing it clockwise using the wrench (7).
To remove a disc:
1. Disconnect the plug from the electrical out-
let.
2. While pressing the spindle-lock button, loos-
en the threaded outer flange (5) by turning it
counter-clockwise using the wrench (7).
3. Remove the threaded outer flange.
4. Remove the disc (4) from the spindle (3).
U se r's m a nua l
7
5
4
2
1
3
6
11
Tabla de contenido
loading

Tabla de contenido