Urrea LE834 Manual De Usuario página 18

3. Insert the open-
ing of dust bag (5)
through the clamp (6),
and release the clamp
handle (7).
4. Attach the opening
of dust bag (5) to the
dust exhaust (3), and
lock the clamp (6) to
secure the dust bag
(5).
MOUNTING BELT / DISC SANDER TO WORK-
BENCH
CAUTION: If during operation there is any
tendency for the sander to tip over, slide or
walk on the supporting surface, it is recom-
mended that you mount the sander on a flat
and level workbench or stand to avoid any
movement during operation. Four mounting
holes are located on the base of the sander for
this purpose.
1. Place the sander on a surface that is level but
also provides enough room on all sides for the
workpiece and for the operator (or bystanders)
to not be standing in line with the wood while
using the tool. Allow room for the belt to be
positioned horizontally or vertically.
2. The hardware to mount this sander is NOT
supplied with the sander.
Recommended Hardware
(not supplied)
1. Mounting bolts.
2. Lock washer.
3. Hex nut.
4. Sander base.
WARNING: To avoid injury, always keep
the plug disconnected from the power source
and the switch turned OFF until the sander is
completely assembled and adjusted properly.
ADJUSTING DISC TABLE SQUARE WITH SAND-
ING DISC
1. Using a combination square (1), place one
side of the square on the disc table assembly
18
(2) with the other side against the sanding disc
(3), and check to see if the disc table is 90° to
the disc.
2. If the disc table surface is not 90° to the disc,
loosen the table lock handle (4), adjust table
square with disc and tighten the table lock
handle (4).
3. Loosen the screw (5) and secure the scale
pointer (6) at 0°.
or fingers between the worktable and sanding
disc, the worktable edge should be positioned
a maximum of 1/16 in. (1.6 mm) from sanding
disc plate.
ADJUSTING DISC TABLE ANGLE
1. The disc table (2) can be tilted from 0° to 45°
by loosening the table lock handles (4) at the
both sides of disc table.
2. Tilt the disc table to the desired angle.
3. Tighten table lock handles.
ADJUSTING BELT TABLE SQUARE WITH SAND-
ING BELT
1. Using a combination square (1), place one
side of the square on the belt table assembly
(2) with the other side against the sanding belt
(3), and check to see if the belt table is 90° to
the belt.
2. If the belt table sur-
face is not 90° to the
Bench work table.
belt, loosen the table
lock knob (4), adjust
table square with belt
and tighten the table
lock knob (4).
3. Loosen the screw (5)
and secure the scale
pointer (6) at 0°.
CAUTION: To avoid trapping the workpiece